Glass epoxy paint

What is epoxy glass paint?
 Glass epoxy paint  is an epoxy paint in which the component has super fine glass beads to add superior properties to epoxy paint.


The factory is constructed of epoxy floor coating products coated with glass scale oil

Oil-based epoxy glass paints have many outstanding advantages for concrete floors. Let’s take a look at the advantages and disadvantages of this product.


Apply thicker epoxy glass-based paint, covering small holes on concrete floors better than conventional coatings. Due to the addition of glass components, the paint surface is more shiny, better resistant, better chemical resistant.


Because the paint has more glue, it is more difficult to apply, the surface of the floor is easily discolored when exposed to sunlight.

Where appropriate use:
+ Due to many advantages over conventional epoxy coating, epoxy glass coating is suitable for places where big load such as forklift factory, warehouse, parking … Where chemical resistance High quality substances such as chemical plants, processing factories of agricultural, forestry and aquatic products, … Places that require high hygiene such as food production plants, drug manufacturing …

Technical details for the application of oil-based epoxy glass coatings should be done by a long-time, highly experienced technical team.

If you have any questions, please contact BRY here for free support.


The process of applying oil-based epoxy glass coating consists of 9 basic steps

Step 1: Grinding concrete foundation

Conducting ground grinding with an industrial grinding machine with industrial vacuum cleaner to have a relatively flat surface, removing dirt from the substrate, reclaiming the base where needed. Sharpening the corner, the wall, removing the debris and concrete chips to get a more perfect concrete block. Remove grease, chemicals with specialized detergents, large gas burners. Vacuum, clean the entire surface

Step 2: Fill out

Priming in front of positions to fill Plaster large defects of fast-hardening putty surfaces. Rewind the fillings, check the entire surface for a relatively flat surface. Vacuum, clean the entire surface

Step 3: Apply epoxy primer paint

The epoxy primer penetrates deep into the concrete floor to form a durable composite layer, hardening the concrete, creating a good bond between the concrete and the coating. Construction by rolling, brushing or spraying method. Using a brush on positions that cannot be touched such as a chassis, a wall The primer must be covered on the surface, where the primer is too primed to be covered with primer again.

Step 4: Apply epoxy coating to water 1

After dry primer (> 1 hour) Apply the first epoxy coating. This layer must be painted evenly and colorfully the entire concrete floor.

Step 5: She fixes the surface

After executing color epoxy paint, the defects of the surface reveal more clearly. Carry out a self-leveling spill to ensure that all small holes in the surface are covered, even as small as a toothpick. This is an extremely important step to ensure the aesthetics of concrete floors. Fillings complement deep, wide defects with putty. Recheck with tape sanding machine

Step 6: Scrub the surface

Use a large sanding machine to scrub and remove all particles and sand particles adhering to the epoxy floor surface.

Step 7: Check

Check all concrete floors, If not, go back to step 5 This step BRYepoxy evaluates to be extremely important. Because after this step the floor repair work to achieve the highest aesthetic is more difficult and expensive.

Step 8: Apply the final epoxy coating.

Apply roller or spray the entire surface of the final epoxy coating. Note that on a flat surface should not be applied twice to avoid different paint colors. Using the brush to sweep the corner, the foot of the walls is unreachable Avoid rolling, spraying on the wall, rolling to roll the roller

Step 9: Last check

Check the entire surface after construction to ensure technical requirements, art ... before handing over to investors. Application of epoxy coatings with oil-based coatings needs to be done manually with a short fiber brush, rulo epoxy-based oil or using vacuum spraying method. Use glasses, gloves, gas masks, protective gear to ensure safety during construction.